Fiber laser cutting machine will generate a lot of heat in the processing of sheet metal,under normal circumstances, the heat generated by the cutting will spread along the seam then sufficiently cooled.Fiber laser cutting machine cut hole processing,the outer holes can be fully cooled,while single-hole orifice part because of the small space inside,so heat can be diffused and too concentrated to cause over-burning.other reason,when cutting the thick metal sheet, the fiber laser cutting machine produced accumulation molten metal in surface of the material causes the accumulation of secondary turbulence,excessive heat input,causing burnt edges.
The sulution of burning edge of fiber laser cutting machine:
when cutting the carbon steel holes ,assist gas is oxygen.The key is to how to suppress the oxidation reaction heat generation.
Supplementary oxygen can be used when perforation,after switching to the secondary air or nitrogen to cut.In this way the maximum workability 1/6 slab hole. Low frequency,high peak power pulsed output cut to reduce heat output to help optimize cutting conditions.The conditions were set to a single pulse laser beam,a large energy peak output intensity,low frequencies,can effectively reduce the accumulation of the molten metal during piercing of the material surface, effective to inhibit heat output.
2.When fiber laser cutting aluminum and stainless steel : the auxiliary gas is nitrogen,the cutting edge won’tburn,however,due to the high temperature of the inside the material,dross inside the more frequent.
Effective solution is to increase the pressure of the auxiliary gas, the condition is set to peak output, low frequency pulse condition.
More informations about fiber laser cutters ,please contact us !
Jinan Ruijie Mechanical Eqipment Co., Ltd.
Post time: Feb-13-2019